How To Program A Charter Universal Remote

If you just bought a Charter Universal remote control and searching for how to sync it with device, you have come to the right place. With the Charter universal remote, you can program it and use it to control different gadgets at once. So instead of switching between multiple remotes when you want to switch the volume on your TV and DVD player, you can use your universal remote to do so.

Thankfully, like most universal remotes out there, the Charter remote comes with the ‘Code Search’ option. Also, the process of how to program a Charter universal remote is easy. A newbie can get it done in minutes by following the steps listed below.

How To Program A Charter Universal Remote With Code

Step 1. Ensure you turn on the device you want to sync with the universal remote.

Step 2. Hold your Charter remote to face the device you want to program.

Step 3. Find and press the TV Power key on your remote.

Step 4. Press and hold the SEL and TV buttons simultaneously. Continue to hold both buttons until the tiny LED blinks twice.

Step 5. Go to this post and find the Charter universal code that suits your TV.

Step 6. Enter the code and press the TV Power button. If your TV turns off viola, you have synced your TV with your remote. If not, try another code from the list of codes. Finally, if none of the codes works for your TV, you can try using the second method outline below.

Also Read  How To Program a GE Universal Remote

How To Program A Charter Universal Remote With Code Search

Step 1. Ensure you turn on the device you want to sync with the universal remote.

Step 2. Hold your Charter remote to face the device you want to program.

Step 3. Find the power-up button on the remote and press to suit the device you want to sync. For instance, if you want to sync a TV, Press the ‘TV’ key. For a DVD, press the ‘DVD’ option.

Step 4. You will find the ‘Setup’ button at the top of the remote control. Hold down the button for several seconds until the tiny LED light on the remote blinks three times. After that, you release the ‘SETUP’ button.

Step 5. Press 9-9-1. If you get this right, the tiny LED light on top of the remote control will blink twice.

Step 6. After that, press the ‘1’ button if you want to program the remote to a TV. Press the ‘0’ if you want to program the remote to a satellite/Cable. Finally, if you want to program the remote to an Audio/VCR device, enter ‘2’.

Step 7. Find and press the ‘Power’ button on top of the remote. After that press, the ‘CH+’ on the remote a couple of times until the device you want to program turns off.

Step 8. Finally, press the ‘SETUP’ button again and hold it until the tiny LED light blinks twice again.

Voila. You have successfully programmed your Charter universal remote.

Leave a Reply

Your email address will not be published. Required fields are marked *